Soldering components¶

In this step, place the following three components onto the pins which were placed earlier. These components are then soldered onto the pins.

AdaFruit Temp/Humidity Sensor¶

Place the Temp/Humidity sensor onto the 7-pin header and solder in place as shown in the image below.

OpenLog SD card data logger¶

Place the OpenLog onto the 6-pin header and solder in place as shown in the image below.

Pololu 3V3 power regulator¶

Place the Pololu 3V3 module onto the 4-pin header and solder in place as shown in the image below.